Dutch Weave
Dutch or Hollander Weave is a description applied to woven wire cloth where the diameter of the warp and weft wires, and the mesh count in the warp and weft directions, are different.
The wires are driven up much closer during the weaving process, thus producing a more densely compacted media.
Mesh count per inch and aperture size in microns are the most commonly used methods of describing the various Dutch Weave specifications.
We offer four standard weave types all available in Stainless Steel.
Plain Steel, Monel and non-ferrous alloys are available in a limited number of specifications.
Twill Dutch Weave
Each warp wire and each weft wire passes
over and under the next two adjacent complementary wires, as in a normal
Twill Weave, except the warp wires are larger in diameter than the
weft wires.
This allows a greater mesh count in the weft direction.
This weave pattern enables the weft wires to be woven more densely, and much smaller aperture sizes can be achieved without foresaking cloth thickness.
Plain Dutch Weave
Each warp wire and each weft wire passes over and under
the next adjacent complementary wire, as in normal Plain Weave, except
the warp wires are larger in diameter than the weft wires.
This allows a greater mesh count in the weft direction.
Reverse Dutch Weave
This wire mesh is woven in the reverse manner to plain and twill Dutch weaves.
Absolute Micron Retention
In all types of Dutch Weaves the sum derived from multiplying the number of weft wires in a given measurement by their diameter, results, in theory, in a specification with no open space. Because the wires are driven together during the weaving process, the aperture size cannot be calculated in the normal manner.
There are two methods by which the aperture size can be determined.
BUBBLE POINT TEST- The pressure required to pass air bubbles through the mesh (covered by a test liquid) is measured. The average aperture size is then calculated by taking into account surface tension, liquid density, temperature and immersion depth.
GLASS BEAD TEST- A suspension containing glass beads is passed through the mesh - the diameter of the largest bead passing through is considered as the absolute micron retention.
All our wire mesh is manufactured in accordance with International Standards.
For further information see the Buyers Guide and FAQ.
Experienced engineering staff based at our Design and Technical Centre are also available to offer advice and guidance.